follow ft86club on our blog, twitter or facebook.
FT86CLUB
Ft86Club
Speed By Design
Register Garage Community Calendar Today's Posts Search

Go Back   Toyota GR86, 86, FR-S and Subaru BRZ Forum & Owners Community - FT86CLUB > Search Forums
Reload this Page Search Results


Page 1 of 17 1 234511 Last »
Showing results 1 to 30 of 500
Search took 0.44 seconds. Search: Posts Made By:
Forum: Engine Swaps Today, 12:10 PM
Replies: 347
Views: 76,871
Posted By removedonut
That’s gonna depend pretty heavily on the salvage...

That’s gonna depend pretty heavily on the salvage yard pulling the engine lol. Most are monkeys and would sooner just cut a hard line than put the effort in to disconnect it.
Forum: Member's Car Journals Today, 04:47 AM
Replies: 76
Views: 12,409
Posted By autoracer86
Over the weekend I installed my latest mods The...

Over the weekend I installed my latest mods The MCA traction mod V2 and STi trailing arms. It's still a bit early to draw a full conclusion on them but I was shocked how much better it was down one...
Forum: Suspension | Chassis | Brakes -- Sponsored by 949 Racing Today, 03:45 AM
Replies: 288
Views: 92,013
Posted By autoracer86
MCA traction mod and STi trailing arms installed....

MCA traction mod and STi trailing arms installed. Made a noticeable difference in the way the car goes over bumps. Had a quick drive on one of my favorite back roads and was shocked at how much more...
Forum: Engine Swaps 05-24-2024, 09:16 PM
Replies: 347
Views: 76,871
Posted By removedonut
Bof. Auto should actually be slightly...

Bof.

Auto should actually be slightly easier since all FA24s have a vacuum pump setup like the automatic FA20s did, whereas on the MT cars you have to do some brake booster rerouting.

My 2013...
Forum: Off-Topic Lounge [WARNING: NO POLITICS] 05-24-2024, 09:01 PM
Replies: 3,775
Views: 500,457
Posted By The Red One
https://cdn-1.motorsport.com/images/mgl/Yv8qbQG0/s...

https://cdn-1.motorsport.com/images/mgl/Yv8qbQG0/s800/duracell-bunny-on-the-car-of-l.jpg

I like where this is going with the Wabbit!
Forum: Issues | Warranty | Recalls / TSB 05-24-2024, 07:07 PM
Replies: 19
Views: 1,128
Posted By gen3v8
Can change the torque up to 40%:confused0068:.Yes...

Can change the torque up to 40%:confused0068:.Yes I use some copper grease:confused0068:. Makes me wonder what level of destruction others have applied for a failure. I start by hand, use a rattle...
Forum: Issues | Warranty | Recalls / TSB 05-24-2024, 06:46 PM
Replies: 19
Views: 1,128
Posted By Ultramaroon
To be clear, I'm on my original wheel studs/nuts....

To be clear, I'm on my original wheel studs/nuts. I only became curious after reading all the horror stories. Wheels are removed a few times annually.

The stock acorn nuts are pretty sloppy but,...
Forum: Off-Topic Lounge [WARNING: NO POLITICS] 05-24-2024, 03:11 PM
Replies: 1,199
Views: 244,116
Posted By Kaotic Lazagna
Unedited pic from the phone. I'll edit the RAW...

Unedited pic from the phone. I'll edit the RAW files later and see if they come out better than the phone's "auto" mode.
Forum: Forced Induction 05-24-2024, 03:02 PM
Replies: 126
Views: 96,385
Posted By CSG Mike
Because it's discontinued.

Because it's discontinued.
Forum: Member's Car Journals 05-24-2024, 02:39 PM
Replies: 19
Views: 2,536
Posted By grippgoat
Got the RaceChrono GoPro import figured out. ...

Got the RaceChrono GoPro import figured out. It's actually pretty straightforward, and not so bad when I'm just grabbing 1-2 vids for the part of my best session that I want to overlay. It's...
Forum: Issues | Warranty | Recalls / TSB 05-24-2024, 12:53 PM
Replies: 19
Views: 1,128
Posted By NoHaveMSG
I've never messed up a stock stud either but I...

I've never messed up a stock stud either but I always run them on gently.

Highly advise against anti seize or any type of thread lubricant. Has a drastic effect on torque.
Forum: Off-Topic Lounge [WARNING: NO POLITICS] 05-24-2024, 12:36 PM
Replies: 1,909
Views: 93,652
Posted By StraightOuttaCanadaEh
that Silvia time trial was the hardest in a...

that Silvia time trial was the hardest in a while. Managed to eke out a gold time but took me like 40-50 laps to do that. I don't think it's gonna last either
Forum: Off-Topic Lounge [WARNING: NO POLITICS] 05-24-2024, 10:05 AM
Replies: 1,909
Views: 93,652
Posted By WolfpackS2k
Congrats! Also damn you. You always whip my...

Congrats!

Also damn you. You always whip my ass in our Thursday night races lol
Forum: Issues | Warranty | Recalls / TSB 05-24-2024, 01:42 AM
Replies: 19
Views: 1,128
Posted By humfrz
Yep, I got the picture - ;)

Yep, I got the picture - ;)
Forum: Scion FR-S / Toyota 86 GT86 General Forum 05-24-2024, 01:31 AM
Replies: 2,034
Views: 347,419
Posted By humfrz
Pushed mine back in the garage about a foot to...

Pushed mine back in the garage about a foot to get the trash cans out. I did not crash it - by pushing it back into the garage door.

:iono:
Forum: Off-Topic Lounge [WARNING: NO POLITICS] 05-23-2024, 11:33 PM
Replies: 653
Views: 71,007
Posted By Sapphireho
Book of boba fett was the western one. I didn't...

Book of boba fett was the western one. I didn't get a western vibe from mandilorian.
Forum: Scion FR-S / Toyota 86 GT86 General Forum 05-23-2024, 11:07 PM
Replies: 2,034
Views: 347,419
Posted By Sapphireho
Drive mine today. had no problems. Did not...

Drive mine today. had no problems. Did not crash.
Forum: Engine Swaps 05-23-2024, 09:11 PM
Replies: 347
Views: 76,871
Posted By removedonut
Fingers crossed for no snags on that one. All my...

Fingers crossed for no snags on that one. All my stuff is installed on the motor, shop should be dropping it in any minute now.
Forum: Off-Topic Lounge [WARNING: NO POLITICS] 05-23-2024, 07:49 PM
Replies: 1,909
Views: 93,652
Posted By Kaotic Lazagna
Finally past 200k collector points.

Finally past 200k collector points.
Forum: Engine Swaps 05-23-2024, 07:10 PM
Replies: 347
Views: 76,871
Posted By removedonut
17-20 test car is up and running with my kit....

17-20 test car is up and running with my kit. I’ll have a video posted and the kits up for sale sometime next week after I’m back from vacation. Final price is going to be $300 for the 17-20 harness...
Forum: Member's Car Journals 05-22-2024, 06:29 PM
Replies: 38
Views: 7,926
Posted By SOCON
Serviced today 117k miles.

Serviced today 117k miles.
Forum: Tracking / Autocross / HPDE / Drifting 05-22-2024, 06:28 PM
Replies: 15
Views: 850
Posted By 2.2Lude
+1. Found it online. Made by GK ENGINEERING : ...

+1. Found it online. Made by GK ENGINEERING :

https://gkengineering.co/products/universal-two-piece-hood-louvers-aggressive-0-063-thickness-standard?variant=40806949355568
Forum: Tracking / Autocross / HPDE / Drifting 05-22-2024, 04:22 PM
Replies: 15
Views: 850
Posted By jflogerzi
you cant post this without sharing info :slap:

you cant post this without sharing info :slap:
Forum: Engine Swaps 05-22-2024, 02:58 PM
Replies: 347
Views: 76,871
Posted By removedonut
With the way i’m building the harnesses, nobody...

With the way i’m building the harnesses, nobody needs to repin anything (besides the fuel pressure sensor, for 13-16 cars). I am building modular jumper connectors that leave the FA20 harness totally...
Forum: Engine Swaps 05-22-2024, 02:01 PM
Replies: 347
Views: 76,871
Posted By removedonut
- Threads and sensor lengths are different for...

- Threads and sensor lengths are different for oil and coolant temp, so we can’t reuse those from the FA20.
- On the 17-20, reusing the FA20 crank position sensor would create the same problem as...
Forum: Off-Topic Lounge [WARNING: NO POLITICS] 05-22-2024, 11:37 AM
Replies: 619
Views: 77,964
Posted By Sapphireho
You did in the RT thread. ...

You did in the RT thread.

https://www.ft86club.com/forums/showpost.php?p=3589436&postcount=8469
Forum: Engine Swaps 05-22-2024, 10:00 AM
Replies: 347
Views: 76,871
Posted By removedonut
For the FA24 swap? In my kit, we use the FA20...

For the FA24 swap? In my kit, we use the FA20 wiring harness with a few adapters that allow it to connect to the FA24.
Forum: Suspension | Chassis | Brakes -- Sponsored by 949 Racing 05-22-2024, 09:06 AM
Replies: 288
Views: 92,013
Posted By DocWalt
Super frustrating to me that the traction mod...

Super frustrating to me that the traction mod isn't legal for SM even though effectively the same geometry change is legal by spending a LOT of time and money modifying the knuckle or building a new...
Forum: Off-Topic Lounge [WARNING: NO POLITICS] 05-22-2024, 07:29 AM
Replies: 998
Views: 227,815
Posted By Wally86
If you've been on the fence about getting a...

If you've been on the fence about getting a suppressor because of the wait times and you haven't heard the news....

Less than 4.5 days to approval :D
...
Forum: Issues | Warranty | Recalls / TSB 05-22-2024, 04:20 AM
Replies: 19
Views: 1,128
Posted By ZDan
Yeah, factory wheel studs *and* nuts are...

Yeah, factory wheel studs *and* nuts are horrifically bad. They *will* bugger up and ruin your day. On the old car ('17) I had gone to ARP studs but stupidly kept using the factory nuts. Sure...
Showing results 1 to 30 of 500
Page 1 of 17 1 234511 Last »

 
Forum Jump

All times are GMT -4. The time now is 04:11 PM.

Contact Us - Toyota GR86, 86, FR-S and Subaru BRZ Forum - FT86CLUB - Archive - Privacy Statement - Terms of Service/DMCA Policy - Top

Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
User Alert System provided by Advanced User Tagging v3.3.0 (Lite) - vBulletin Mods & Addons Copyright © 2024 DragonByte Technologies Ltd.

Garage vBulletin Plugins by Drive Thru Online, Inc.