Toyota GR86, 86, FR-S and Subaru BRZ Forum & Owners Community - FT86CLUB - View Single Post

nlowell · 09-07-2015, 12:00 PM

Sorry if this is a thread jack but this is the only active thread on AIM that I see on the forum. Just installed my MXS and when I connect the USB cable to my Surface 3 nothing happens in Race Studio 3 - says no device detected. Is there something special I need to do?

*EDIT* Manually installed the USB drivers from the AIM folder and re-connected all plugs - it now works!

Anyone find a way to display the following:
- Display AFR as a calculation of LAMBDA?
- Use a warning light when a DTC has triggered?
- Display boost as a differential between barometric pressure and MAP?

09-07-2015, 12:00 PM	#31
nlowell Senior Member Join Date: May 2013 Drives: 2013 Scion FRS Location: Dallas, TX Posts: 443 Thanks: 105 Thanked 409 Times in 173 Posts Mentioned: 51 Post(s) Tagged: 0 Thread(s)	Sorry if this is a thread jack but this is the only active thread on AIM that I see on the forum. Just installed my MXS and when I connect the USB cable to my Surface 3 nothing happens in Race Studio 3 - says no device detected. Is there something special I need to do? EDIT Manually installed the USB drivers from the AIM folder and re-connected all plugs - it now works! Anyone find a way to display the following: - Display AFR as a calculation of LAMBDA? - Use a warning light when a DTC has triggered? - Display boost as a differential between barometric pressure and MAP? __________________ Complete Part Out: http://www.ft86club.com/forums/showthread.php?t=125688 Last edited by nlowell; 09-07-2015 at 12:58 PM.