Thread
:
NASA ST4 - U build thread - engine swapped
View Single Post
08-22-2022, 12:19 PM
#
13
gt5759
Senior Member
Join Date: Nov 2021
Drives: 2017 BRZ
Location: central US
Posts: 112
Thanks: 191
Thanked 278 Times in 95 Posts
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Well for better or worse the firewall and filler panels are done. Tried to do the main firewall in two panels and bit off more than I could chew, my bead roller is only a 18" and I really needed a 24" or bigger, i couldn't quite reach the center on a couple of the beads
I am really pleased with the design and the fitment but I might do them over as it really irritates me on those spots but then again the seats go in front of it. I'll keep progressing and come back to that later, I still need to finish the small filler pieces from the cage to the body to seal it off but that's not a huge deal.
Last edited by gt5759; 08-22-2022 at
12:45 PM
.
The Following 3 Users Say Thank You to gt5759 For This Useful Post:
RedReplicant
(08-22-2022),
villainous_frx
(08-22-2022),
Wally86
(08-22-2022)
gt5759
View Public Profile
Send a private message to gt5759
Find More Posts by gt5759