Quote:
Originally Posted by mrntd
I had the same problem. I sanded the banjo bolt and used the original washers. No problem after that.
|
Quote:
Originally Posted by localhost
I had the exact same problem with a super fine stream of fuel leaking. No amount of pressure on the bolt would fix it so I ended up getting a set of OEM washers. This fixed the problem completely because it's a much more soft material and actually made a good seal unlike the super stiff one they supply you with in the kit.
I didn't feel like sanding a bolt was a good solution (personal preference I guess) which is why I ended up using a new OEM crush washer there instead of the supplied one.
|
Thank you both!
I'm going to get a new pair of OEM washers then and see if that does it. However, I can't find a part number anywhere. Are they called fuel rail crush washers? I've seen some online but not sure if they're vehicle specific - most just have a huge selection of Toyota/Subaru vehicles they fit. Also, the size should be 12mm, correct? I don't see any size specs for any of them. Would just ordering a "12mm aluminum crush washer" from Amazon work too?
I can't believe this little bolt has been the most challenging part of the entire install. Lol.
