Quote:
Originally Posted by vividracing
Why would I state that ONLY FRS/BRZ componets are the being made in the U.S.A. Do you know any different? AP was behind in making the 1st run because the AP guys were working on finishing up some 997TT and BMW parts. In House!
http://www.agency-power.com/catalog/...ID=24&CDpath=0
Where are you getting your facts on this is Chinese knock off stuff? I do not see it posted in link. I mean if we are going to get technical right? "overseas" Doesn't say China. Next, you also claim you knew they were made in China in the 1st thread., but now state you were not aware things have changed. So you really do not know what you are talking about then right. So it would be safe to say maybe you should slow it down. I mean you just made a mistake right? So should I now try and hang you for it? I will point it out but not charge after you over it.
Next you do not listen. The Header is made in house. People that have stopped by have also told you its being made in house. They have seen how its made. And no I am not going to post how we do it. Its been said over and over again.
Now I might check back in here between now and Monday. But since I have weekends off. I missed a Subaru Event invite to Pismo and have a family life. I'm going to go enjoy my day.
Thanks!
. |
Well I'm not too concerned about this mistake (where exactly 'overseas' are they made then?). Partly because the link was not available and I even stated at the time that I was unsure anticipating that there would be a correction rather than vague innuendo and a customer or two that saw a jig. You need jigs to make prototypes. You also cut up and tacked together that STI/Legacy GT header as a prototype. So I'm putting two and two together. The flange to primary sections and collectors are identical as is the secondary collector.
And as to relying on your statements, well your track record on this site isn't that great. We get the website saying 'overseas' and you saying 'in house'. So in between would be a reworked overseas part.
I think I'm doing a pretty good job listening, how about you? How did you miss the flywheel checking suggestion I made early on?